Question Mq2Bot troubleshoot

[Thalowin]

Ok so all classes work for me using this except my cleric and my sk.

SK is lvl 105 and it will cast all spells but wont engage melee ?
I have to manually attack mobs it wont just assist .

as for the cleric I tried on my lvl 95 cleric and on a 105 cleric it will self buff and then just assist and target the Mob I am killing.

any ideas

all other classes function properly when in use.
war works fine
pally works fine dru enc also np
mage is good to go

just the sk and cleric not working for me

any input is appreciated

Thank you

 

[Dealings]

too vague

so based on the broad question just gonna spit ball an solution

1)load the spells you are gonna use (heals , aggro taps etc)

2)MAKE SURE ASSIGN A MT AND DO YOUR XTAR 1 ACCORDINGLY (had to stress that)

3)for cleric check the ini entries (though they seem to work right from start)

4) make sure melee is loaded,moveutils is loaded

 

[Thalowin]

Sorry I didn't think it was vague but sorry if it was .
everything that needs to be on moveutils mellee spell etc everything is on.

I always set main tank main assist.
as I mentioned every class works except for the cleric and the shadow knight every other class I use I have no issues with.

Cleric will self buff then just stand there not healing .. and yes full spell bar full of the needed heals.

Shadowknight will assist and cast spells range doesn't matter will not engage with mellee unless I press the attack key. then it goes into full on taunt etc .

X TAR sorry I don't know what that is.

 

[Dealings]

extended target, set 1st one as group assist target

set your main assist (sk)

 

[PeteSampras]

Turn on the debugger and see what it says. The plugin tells you everything it is trying to do. DoDebug=1